HAMPTON BAY 434 346 Manual Del Propietário página 12

Fan Without Light Kit
1. In order to use the fan without the light kit,
remove the switch cup cover from the top
of the light kit fitter by removing the cen-
ter hex nut inside the switch cup cover, and
then thread the switch cup cover off of the
threaded nipple on the top of the light kit
fitter.
2. Press the plastic plug (provided) into the
center hole of the switch cup cover.
3. Remove the three screws from the switch
cup cover of the light fitter.
4. Align the three screw holes in the switch cup
cover with the three holes in the switch cup.
5. Position the switch cup cover onto the
switch cup and install the three screws that
were removed in step 3. Tighten the three
screws (Figure 18).
TO AVOID POSSIBLE FIRE OR SHOCK, THE
CONNECTORS SHOULD BE REMOVED UNLESS
A LIGHT KIT WILL BE IMMEDIATELY INSTALLED
AND THAT POWER SHOULD BE TURNED OFF
PRIOR TO CONNECTOR REMOVAL LIGHT KIT
INSTALLATION.
10.
Mounting
Screw(3)
Plastic Plug
Blade Balancing
All blades are grouped by weight. Because nat-
ural woods vary in density, the fan may wobble
even though the blades are weight matched. The
following procedure should correct most fan
wobble. Check after each step.
1. Check that all blade and blade bracket
screws are secure.
2. Most fan wobble problems are caused when
blade levels are unequal. Check this level by
selecting a point on the ceiling above the tip
of one of the blades. Measure from a point
on the center of each blade to the point on the
ceiling. Measure this distance as shown in
Figure 19. Rotate the fan until the next blade
Figure 18
is positioned for measurement. Repeat for
each blade. Measurement deviations should
within 1/8". Run the fan for 10 minutes.
3. If the fan continues to wobble please contact
Customer Service and a balacing kit will be
sent to you at no charge.
Figure 19