Publicidad
Idiomas disponibles
Idiomas disponibles
This Start Guide explains how to use the TG-140 from the front panel:
On/Off switch: this is the power switch on the back of the equipment. You have to turn it on
after plugging in the equipment. Do not use this switch to turn off the equipment, use the
On/Off button in the front of the panel.
On/Off button: this is the red button on the front of the equipment. To turn on the TG-140
just press and release the On/Off button. The TG-140 takes about 1 minute to start up. If it
takes more time it is probably due to a check disk which happens every 30 starts or when
recovering from a bad shut down. You know the TG-140 is ready for operation when the
LCD screen does not display "Initializing...". To turn off the TG-140 press and release the
"On/Off" button. The TG-140 will take less than one minute to completely power off.
Pressing this button more than four seconds and then releasing it will force an emergency
power off.
Menu button: when you press the Menu button you go back one item of the menus
hierarchy.
Knob: pressing the Knob means "Execute" or "Ok" to go to the next level of the Menu
hierarchy. Moving the knob left and right shows the menus of the same hierarchy level.
When power is restored after a power cut the equipment will start up in the same state it was
when the power went down.
To play a Transport Stream file follow this sequence of menus.
To record a Transport Stream File follow this sequence of menus.
Make sure the TG-140 has input signal before starting to record.
To configure the IP Address go to the following menu and set the IP Address.
General Configuration/IP Config/Static IP Config/New IP
Press Menu one time to go back. Do not press the Menu button two times or the filled IP will be
loosed.
To configure the Gateway follow the next menu:
General Configuration/IP Config/Static IP Config/New Gateway
Set the Gateway address. If you have no Gateway address fill it all with zeroes.
Press Menu one time to go back. Do not press the Menu button two times or the filled IP will be
loosed.
To apply the changes follow the next menu:
General Configuration/IP Config/Static IP Config/Apply Changes
Press the Knob and the changes will be applied.
PROMAX ELECTRONICA, S. L.
Francesc Moragas, 71-75 * 08907 * L'HOSPITALET DE LLOBREGAT (Barcelona) * SPAIN
Tel.: 93 184 77 00 * Tef. Intl.: (+34) 93 184 77 02 * Fax: 93 338 11 26 * Fax Intl.: (+34) 93 338 11 26
http://www.promaxelectronics.com * e-mail: promax@promaxelectronics.com
TG-140
USER'S QUICK GUIDE
Local Control/Player/Play
Local Control/Recorder/Record
User's Quick Guide TG-140
Publicidad
