Installation; Assembly; Electric Connections - Aqua ECO-WASH Manual De Instrucciones

STANDARD CONSOLE
Control console for eco•wash system
2.0

INSTALLATION

2.1 A
SSEMBLY
Using the provided velcro, position the console on the front of the washing machine facilitating programs selection
by the operator.
 Clean the surface of the washing machine with a cloth, in the point where the console is to be positioned.
 Stick a strip of velcro on the rear of the console and one on the washing machine.
 Place the console on the washing machine.
Velcro
2.2 E
LECTRIC CONNECTIONS

ATTENTION: Before carrying out maintenance on the appliance, always disconnect the power
supply.
 Open the signals module and remove one of the plugs at its sides.
 Assemble the PG7, relating to the telephone cable coming from the console, on the signals module as
shown in the following figures:
Loosen nut of the PG7
Insert PG7 inside hole of the box
 Connect the telephone plug (RJ11) of the cable coming from the console on Console clamp of the signals
module circuit.
 Close the signals module again.
ADSP7000604 rev. 1.3
Remove the nut of the PG7 from the cable
Tighten nut on PG7
17/09/2015
INSTALLATION
ENGLISH
14/62