User Maintenance; Cleaning & Maintenance - Rusk Engineering CURLFREAK IRECF1C Manual Del Usuario

handles are closed together. there will be a series of individual beeps. hold the styler
still, with the handles held together until the end of the individual beeps. there will then
be four quick beeps in succession. this indicates that the time is up and you can remove
the styler from the hair. NOTE: When the audio off 0 setting is selected, there will be no
beep indicator. there will just be a warning beep at 15 seconds.
• It is very important that you release the handles fully, and then gently
pull the styler away from the head to free the hair and reveal the curl
(Figure F).
NOTE: Always release the handles first to set the curl free; if you pull away before you
open the handles, the curl will be straightened out.
• To allow the curl to set, do not comb or brush the hair until it cools.
• Repeat around the head until you have the amount of curls desired.
SMART TECh ®
curl FreAK comes with 3 functions for added safety and energy savings.
• Auto Shut Off: if the appliance is switched on for more than 60 minutes continuously,
it will automatically switch off. if you wish to continue using the appliance, simply slide
the switch to off position and then slide the switch to the relevant setting to turn the
power on.
• Sleep Mode: After 20 minutes of idle time, the temperature drops to around 300°F/150°c.
• Motion Sensor: move the iron and close it to trigger the reheat to set temperature.
IRECF1C IB-13_157A.indd 10-11

USER MAINTENANCE

the appliance may require cleaning due to a buildup of residue from hair products.
• Ensure the unit is switched off, unplugged and cool.
• Using a damp cloth and mild detergent or soap, wipe the appliance.
• Ensure the unit has dried thoroughly before re-using.
never allow the power supply cord to be pulled or twisted. never wrap the cord
F
around the unit. damage will occur at the high flex point of entry into the unit,
causing it to rupture and short circuit. inspect the cord frequently for damage. stop
use immediately if damage is visible or if unit stops or operates intermittently.
CLEANING & MAINTENANCE
it is very important that you use the cleaning tool included with
your curl Freak to regularly clean the curl chamber. this will
prevent a buildup of product to ensure the curls produced are
always perfectly formed.
• Ensure the appliance is switched off, unplugged and cool.
• Lightly dampen the cleaning tool with warm water and mild detergent or soap.
• Insert the tool fully into the curl chamber cavity as per the diagrams below.
• Rotate the tool around the curl chamber to remove any buildup of product.
• Ensure the appliance has dried thoroughly before re-using.
• The cleaning tool can be used numerous times; just remove the felt pads, rinse
them in warm, soapy water and let dry before using again.
CAUTION
8/1/13 4:11 PM