Using The Remote Control - Marmitek GIGAVIEW820 Modo De Empleo

Power
Source LED
LED
Transmitter
static
Transmitter
purple /
Static blue /
Receiver
Receiver Off
static
red
Static red Off
Flashes
Flashes
blue
Flashes 3x
per second
Flashes 1x
Static blue
per second
Static blue

4.2 Using the Remote Control

Button Function
Switches the GV820
POWER Receiver/Transmitter
on/off.
Shows information
about 'Channel', the
INFO selected 'Source'
and the 'Signal
Quality'
Switches between
SOURCE Source 1 and
Source 2.
Manually choose
another frequency if
CHANNEL
you have sound or
picture problems.
In 'Disable' position
as standard, 'Enable'
provides a greater
WIDE
range between
Transmitter and
Receiver.
GIGAVIEW820™
Mode Status description
No connection between Transmitter and
Loop-
Receiver but Loop-through function at
through
Transmitter is ON.
Lowest power consumption function, all
Standby
functions are off.
System is starting up, wait at least 1
Starting up
minute to establish a connection.
No input signal available from chosen
source.
Connection
between
Video resolution is not supported
Transmitter
and
Receiver
Video resolution is recognised and
connection between transmitter and
receiver is stable.
Operating
Point at the Receiver
to switch on
'Standby' mode.
Point at the
Transmitter to switch
on 'Loop-through'
mode.
Press once to show
this information on
the HDTV or
Projector connected
to the Receiver.
Press once to
change Source.
Press once to give
status. Press a
second time within 5
seconds to choose
another frequency.
Press once to switch
between these two
settings. Note that
maximum resolution
in 'Enable' setting is
1080i.
OSD Display
No OSD Display active
No OSD Display active
'Searching available
channels' followed by
'Verifying'
'No Signal'
'Not Supported Format'
INFO
POWER
CHANNEL
WIDE MODE
ON / OFF
SOURCE
1 - 2
7