Craftsman 358.348360 Manual De Instrucciones página 7

• The line will easily remove grass and
weeds from around walls, fences, trees and
flower beds, but Jt also can cut the tender
bark of trees or shrubs and scar fences.
• For thmming or scalping, use less than full
throttle to increase line life and decrease
head wear, especially:
During light duty cutting.
• Near objects around which the line can-
wrap such as small posts, trees or fence
wire.
• For mowing or sweeping, use full throtfle for
a good clean job.
TRIMMING - Sold the bottom of the trimmer
head about 80 mm above the ground and at an
angle. Allow only the flp of the line to make con-
tact. Do not force tnmmer line into work area.
Trimming
3 in. (8 ¢m)
Above Grou_
SCALPING - The scalping technique removes
unwanted vegetation. Hold the bottom of the
trimmer head about 80 mm above the ground
and at an angle. Allow the tip of the line to strike
the ground around trees, posts, monuments,
etc. This technique increases line wear.
Scalping
MOWING - Your trimmer is ideal for mowing
Jn places conventional lawn mowers cannot
reach. In the mowing position, keep the line
parallel to the ground. Avoid pressing the
head into the ground as this can scalp the
ground and damage the tool.
Mowing
SWEEPING - The fanning action of the rotat-
ing line can be used for a quick and easy
clean up. Keep the line parallel to and above
the surfaces being swept and move the tool
from side to side.
Sweeping
ZIL .=.__....._
EIbWANNIN(5: Disconnect the spark
plug before performing maintenance except
for carburetor adjustments.
CHECK FOR LOOSE
FASTENERS AND PARTS
• Spark Plug Soot
• Air Filter
• Housing Screws
• Assist Handle Screw
• Debris Shield
CHECK FOR DAMAGED OR
WORN PARTS
Contact an authorized service dealer for re-
placement of damaged or worn parts.
• ON/OFF Switch - Ensure ON/OFF switch
functions properly by moving the switch to
the OFF position. Make sure engine stops;
then restart engine and continue.
• Fuel Tank - Discontinue use of unit if fuel
tank shows signs of damage or leaks.
• Debris Shield - Discontinue use of unit if
debris shield is damaged.
iNSPECT AND CLEAN UNIT AND
LABELS
• After each use, inspect complete unit for
loose or damaged parts. Clean the u nit and
labels using a damp cloth with a mild deter-
gent.
• Wipe off unit with a clean dry cloth.