Bebecar ICON Manual De Instrucciones página 11

GB
READ THESE INSTRUCTIONS CAREFULLY BEFORE
USE AND KEEP THEM FOR FUTURE REFERENCE
YOUR CHILD'S SAFETY MAY BE AFFECTED IF YOU DO NOT FOLLOW THESE INSTRUCTIONS
WARNING: This pushchair has been designed to be operated as shown in the instructions supplied.
Not to do so may cause damage and render your guarantee void.
1 - TO UNFOLD: When opening the pushchair with the adjustable handle,
handle.
2 - Pull gently on handle of pushchair, and press down on metal tube of pushchair with your foot as indicated by the
figure, until primary locks engage with a click. The secondary lock will automatically engage.
3 - STEERING - NON-STEERING: The front wheels can be used in either mode.
Slide lever to the upwards position for steering, as indicated in the figure.
For non-steering wheels press red button and lever will slide in a downward position.
NB: When using your pushchair on rough ground we recommend non-steering mode.
4 - BRAKE OPERATION: To apply brake, press down on pedal.
5 - To release brake, pull up the pedal.
6 - TO REMOVE THE REAR WHEEL: Press lever rearwards and at the same time pull the wheel away from the axel
housing.
7 - TO FIT THE REAR WHEELS: Place axel in axel housing and press inwards.
Check by pulling wheel to confirm latching of the axel.
8 - TO REMOVE THE FRONT WHEEL:
is in a upwards position.
9- TO FIT THE FRONT WHEELS:
upwards position.
Place wheel housing into the front leg, pulling upwards on tab and push wheel housing into front leg, until it locks into
position. Check by pulling wheel to confirm latching of the wheel housing.
10- ADJUSTABLE HANDLE HIGHT: Press the two buttons simultaneously and rise or lower the handle bar as required.
11- TO FIT CARRYCOT / SEAT: Seat may be forward or rear facing.
Place carrycot / seat runners in attachment points (B) on both sides. Lower into position (A) and lock will
automatically engage. Ensure seat frame runners are secure at all 4 attachment points (A & B on both sides).
Warning: Check that the pram body or seat unit attachment devices are correctly engaged before use.
TO REMOVE CARRYCOT / SEAT: Push in red button and turn knob while lifting carrycot / seat away from frame.
12- FOLD PUSHCHAIR:
N.B: Please remember to lock the swivel wheels in the non-steering mode before folding chair.
When folding the pushchair
To fold, firstly press the red button and simultaneously, turn the handle collar in the direction of the "FOLD" and the
chair will begin to close.
13- Operate secondary safety device by pulling the plastic tab.
Tilt the chair forward and continue the folding action until the chassis is fully closed.
14- TO STORE PUSHCHAIR: Fold adjustable handle as shown in the figure.
15- BASKET: To attach the basket, pass the webbing and press-stud through the frame as shown.
Attach the back edge of the basket around the rear cross member.
16- HAND BRAKE: The hand brake is intended as to be used whilst in motion. It must never be used as a parking
device. This brake acts on the back wheels. To lock hand brake, insert red plastic hook into teeth of hand brake. To
release it simply pull brake handle and it will automatically unhook itself.
17- TO ADJUST HAND BRAKE: With one hand, hold the metal piece (A) and with the other rotate the metal piece (B).
To increase the braking efficiency, rotate the metal piece (B) clockwise.
NOTE: This adjustment must be made in a gradual manner until a satisfactory level of braking is achieved.
N.B. The front wheels of this chassis can only be removed if the steering button
Pull upwards on tab and at the same time pull the wheel away from the front leg.
N.B. The front wheels of this chassis can only fitted if the steering button is in a
ensure that the adjustable handle is in line with the main
ensure that the handle is in line with the main
handle.