Excell PWZ0163100.02 Operación Manual página 9

OPERATING INSTRUCTIONS (CONT.)
• SAVE ALL INSTRuCTIONS
PRESSURE WASHER OPERATING FEATURES PRESSURE
ADJUSTMENTS
The pressure setting is present at the factory to achieve optimum pressure and cleaning. If you need a lower pressure,
it can be accomplished by these methods.
1. Back away from the surface to be cleaned. The further away you are, the less the pressure will be on the surface to
be cleaned.
2. Change to the 40° nozzle – this nozzle delivers a less powerful stream of water and a wider spray pattern.
CAUTIO N
DO NOT attempt to increase pump pressure. A higher pressure setting than the factory set pressure
may damage pump.
TO USE SPRAY WAND
The nozzles for the spray wand are stored on the top stor-
age panel. See chart to choose the correct nozzle for the
job to be performed.
CHANGING NOZZLES ON SPRAY WAND
D A N GER
RISK OF FLUID INJECTION. Do NOT
direct discharge stream toward persons, unprotected skin,
eyes or any pets or animals. Serious injury will occur.
W A RNING
RISK OF FLUID INJECTION. Do NOT
attempt to change nozzles while pressure washer is run-
ning. Turn engine off before changing nozzles.
1. Pull back the quick connect collar on the spray wand
and hold it in place.
2. Insert the desired quick connect nozzle and hold in place.
3. Slide the quick connect collar forward until it locks into
place.
4. Check that the quick connect nozzle is securely locked
into the spray wand.
Spray
Pattern
Uses
Surfaces*
C AU T ION
*
damage to surfaces such as wood, glass, automotive paint, auto striping and trim, and delicate
objects such as flowers and shrubs. Before spraying, check the item to be cleaned to assure
yourself that it is strong enough to resist damage from the force of the spray.
E106534
0° 15°
Powerful Intense clean-
pinpoint for ing of small
very intensive areas
cleaning
Metal or con- Metal, con-
crete crete, or wood
DO NOT use
on wood
The high pressure spray from your pressure washer is capable of causing
25°
Intense clean- Intense clean-
ing of medium ing of larger
areas areas
Metal, con- Metal, con-
crete, or wood crete, or wood
9 - ENG
40° Soap
Applies clean-
ing solutions
Metal, con-
crete, or vinyl
Copyright © 2013 MAT Industries, LLC
FIG. 7