Snom A150 Guia De Inicio Rapido página 6

QIG A150 Wireless DECT Headset
Headset voice prompts (in English)
Prompt
Mute on
Mute off
Not registered when the call button is pressed on a headset not regis -
Out of range
Low battery
USB Dongle LED status indications
Description of state
Standby mode, no wire-
less device subscribed
In registration mode
(duration 10 seconds)
Standby, wireless device
subscribed
Ready to enter
deregistration mode
After deregistration mode has been confirmed:
1. Duration: 3 seconds
2. Duration: 1 second
3. Back in standby,
no wireless device
subscribed
Pairing
NOTE: The out-of-the-box headset and USB dongle are paired.
Press the key on the dongle for 4 seconds, then place
the headset in its charger. The dongle's red LED dou-
ble-flashes rapidly and turns off when the registration
has been successful, while the headset's LED shows
steady light (green if fully charged, red if charging).
Deregistering
1. Press the key on the dongle for 10 seconds to enter deregistration
mode. After 4 seconds the red LED starts to double-flash; after 10
seconds the LED starts to flash red rapidly, indicating that the dongle
has entered deregistration mode.
2. Release the key and press it again for 1 second to confirm deregistra-
tion. The LED turns green for three seconds, turns off for one second
and then shows steady red light.
6
Voice prompt is heard
when the microphone is muted.
when the microphone is reactivated (unmuted).
tered on a base station.
• in call: When the headset moves out of range.
• when a key is pressed while the headset is out
range.
when the call button is pressed while the battery is
low.
Pattern
Steady
Rapid double
flashes
OFF
Rapid flashing
Steady
OFF
Steady
Green Red
- ON
- ON
- -
ON
ON
- -
- ON
v2018001