Safety Warning - ViSAGE BY-615 Manual Del Usuario

Safety warning

Although your flat iron is easy to operate, for your safety, the
warnings below must be followed:
1. Do not place the flat iron near a heat source.
2. KEEP AWAY FROM WATER! Do not place or store the
appliance where it can fall or be pulled into a tub or sink.
3. Never leave the flat iron unattended while connected to the
electrical outlet.
4. Use the flat iron on a stable work surface away from water.
5. Do not unplug from the wall socket by pulling on the supply
cord.
6. The flat iron must be unplugged:
A. After each use.
B. If it appears to be faulty.
C. Before cleaning or maintenance.
THIS PRODUCT IS INTENDED FOR HOUSEHOLD USE ONLY.
FCC PART 15
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may cause harmful interference, and (2) this
device must accept any interference received, including interferences that may
cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experience radio/TV technician for help.
SAVE THESE INSTRUCTIONS!
Safety instructions
7