Deactivating Automatic Reopening; Deleting The Sensor - Cherubini A520012 Manual De Instrucciones

Following a wind alarm, the motor closes automatically the awning, overriding user
commands until the wind alarm passes. To deactivate the wind alarm, the vibrations
caused by the wind must remain below the threshold set for at least 8 minutes. After
these 8 minutes the awning returns to the position it was in before the alarm, if the
automatic reopening function is active. This pause time is included to ensure awning
protection and to prevent continuous motor movement in the event of sporadic gusts
of wind.
With the automatic reopening system, at the end of the wind alarm, the awning opens
again. From factory this function is not activated in the Blue Wave RX motor, but can be
easily activated with the following command sequence:
Tn: Already programmed remote control
A
+ B
Tn

DEACTIVATING AUTOMATIC REOPENING

The automatic reopening function can be deactivated at any moment with the following
command sequence:
A
+ B
Tn
To delete the Mistral sensor from the motor, an already programmed remote control must
be used. The deleting sequence is the following:
A
+ B
Tn
AUTOMATIC REOPENING
- only with Blue Wave RX motors -
ACTIVATING AUTOMATIC REOPENING

DELETING THE SENSOR

C
Tn
C
Tn
A
Tn
23
C
Tn (2 sec)
A
Tn (2 sec)
set
2 sec