Planet Waves PW-MT-02 Guia De Inicio Rapido página 2

(CONTINUED)
Concurrently the display pendulum will swing
according to the specified tempo.
The comprehensive metronome has many adjust-
able parameters. The functions of each button are
as follows:
Start/Stop – Starts and stops the Metronome
Volume – There is a conventional volume control
on the side of the unit. Adjust the volume to your
desired level buy turning the dial up or down.
Lowering the volume control to the lowest setting
will mute the metronome allowing you to use the
visual elements only
Up/Down Arrow Keys – Pressing the UP and DOWN
arrow keys while in metronome mode will control
the tempo setting. Pressing the UP arrow will raise
the Tempo while pressing the DOWN arrow will
lower the tempo. The tempo can be adjusted from
20 beats per minute to 250 beats per minute. The
current setting is displayed in the lower left hand
side of the display.
TAP Temp - You can also set the tempo by simply
tapping in a steady desired beat on the TAP button.
The tuner will automatically calculate the beats per
minute and apply the setting.
To access the additional parameters of the metro-
nome you must enter the edit menu
BEAT – The BEAT setting allows you to adjust how
many beats there are per measure. For example,
you could practice variable time signatures such as
Metronome Tuner Instructions
2/4, 3/4, 4/4 and so on. Pressing the EDIT key once
enters you into beats per measure adjustment
mode. Upon entering The BEAT value flashes on
the display. While the BEAT icon is flashing, use the
arrow keys to select the desired beats per measure.
After a few seconds of inactivity, the BEAT value
stops flashing and the displayed setting is active.
SUB – The SUB menu allows you to subdivide
the beat in various ways, such as 1/4 notes, 1/8
notes, triplets and so on. Pressing the EDIT key a
second time enters you into sub division adjustment
mode. The SUB value will now flash on the display.
While the SUB value is flashing use the arrow keys
to scroll through the various subdivision options.
The subdivisions can be adjusted between 1 and 32.
After a few seconds of inactivity, the SUB Icon stops
flashing and the displayed setting is active.
Pitch pipe
Pressing the POWER button three times from the
off position enters you into Pitch Pipe Mode. In
this mode the Metronome Tuner will audibly sound
the displayed note. Use the UP and DOWN arrows
to select the desired reference Pitch. Pressing the
START/STOP Will toggle the sound on and off (Note:
the pitch is dependant on the frequency setting of
the tuner).
While in Pitch Pipe Mode, pressing the POWER key
will turn the Metronome/Tuner off.
FOR LANGUAGE TRANSLATIONS, VISIT PLANETWAVES.COM
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
(PW-MT-02)