Stell SHO 1160 Manual Del Usuario página 13

TV set with curved rear wall (Fig. 4B)
First, nd the screws suitable to mount the TV set (H/I): try to screw them manually in the holes at the back
of the TV set. If you feel resistance stop screwing in immediately! Once you nd the screw with the correct
threat proceed according to the drawing 4B. Insert matching washer on the screw (J/K) and then screw the
screw into the bracket A, insert again a washer from the other side J, a spacer L and nally screw the screw
in the TV set. Check if the brackets hold rm.
Using attachments VESA
In case that your TV set requires using the attachments VESA, follow the images 5A or 5B, depending on the
span of the holes of the VESA standard. Fig. 5A describes installation for 200×100 mm span, Fig. 5B describes
200×200 mm span.
Attaching the bracket to the holder
Warning: Handling some TV sets requires help of another person. The manufacturer is not liable for injury or
damage to property caused by improper handling!
First, hook the bracket attached to the TV set (A) to the upper edge of the body of the holder B and slide the
bracket down until it stops (Fig. 6). Then using the supplied Allen key (O) loosen or tighten the screws on the
rear side of the bracket depending on the required tilt of the screen (Fig. 7).
Congratulation, the installation is done. We wish you a pleasant experience while watching TV mounted on
the wall mount.
INSTRUCTIONS AND INFORMATION REGARDING THE DISPOSAL OF USED PACKAGING
Take the used packaging material to the municipal waste disposal.
PRODUCT DISPOSAL AFTER END OF LIFE
Dispose of equipment after the end of life in the designated municipal solid waste place
This product meets all the basic requirements of EU directives that apply to it.
13 – EN