Publicidad
Idiomas disponibles
Idiomas disponibles
A . LINE CORD - The power line cord
must be connected to a gro u n d e d
AC receptacle in accordance with
the voltage and frequency ratings
as listed on the rear panel under
INPUT POWER.
B . FOOTSWITCH - Plug-in connec-
tion
for
the
optional
footswitch (P/N 037659) used to
switch ON/OFF the chorus eff e c t .
Using this jack will override the
c h o rus select switch on the fro n t
panel. NOTE: Any good quality patch cord will work with the re m o t e
footswitch, however an unshielded speaker type cord is preferable to a
coax guitar cord .
C . RETURN - This 1/4-inch, stereo, TRS (Tip=Left, Ring=Right,
S l e e v e = G ro u n d ) , line-level input jack is designed to accept signal fro m
an external processing device, such as a digital delay or a chorus unit.
TYPE:
PART NUMBER:
POWER REQUIREMENTS:
POWER AMPLIFIER SECTION
POWER OUTPUT:
SENSITIVITY :
PREAMP SECTION
INPUT IMPEDANCE:
SENSITIVITY FOR FULL POWER:
TONE CONTROLS:
FEEDBACK NOTCH:
STRING DYNAMICS:
PHANTOM VOLTAGE:
SPEAKER COMPLIMENT:
DIMENSIONS:
WEIGHT:
R
e
a
r
P
a
n
R
e
a
r
P
a
n
re m o t e
S
p
e
c
i
S
p
e
c
i
PR 334
022-1302-000 (120V, 60Hz) USA
022-1342-000 (230V 50 Hz) UK
022-1372-000 (100V, 50/60 Hz) Jpn
300W
40W R.M.S. per channel, (80W R.M.S. Total)
into 8Ω @ <.12% T.H.D., both channels driven
640mV @ stereo effects return (both channels)
10MΩ (Inst), 3.6kΩ (Mic), 36.4kΩ (Line/Inst)
12.75mV (Inst), 5mV (Mic), 50mV (Line/Inst)
Treble: +/-15dB @ 15kHz (Inst), +/-15dB @ 15kHz (Mic/Line/Inst)
Mid:
+/-12dB @ 1kHz (Inst)
Bass: +/-12dB @ 100Hz (Inst), +/-12dB @ 50Hz (Mic/Line/Inst)
-10dB from 80Hz to 700Hz (Instrument Channel)
0 to -15dB @ 6.3kHz (Instrument Channel)
+15V DC (Mic)
Two Fender Special Design 8" speaker (P/N 051016)
Single Piezo Horn (P/N 049260)
Height: 15.5 in
Width: 22.4 in
Depth: 10.2 in
43 lbs
Fender
®
, is a registered trademark of FMIC
Product specifications are subject to change without notice.
e
l
F
u
n
c
t
i
o
n
e
l
F
u
n
c
t
i
o
n
D . SEND - This 1/4-inch, stere o ,
E. INSTRUMENT INSERT - This 1/4-
f
i
c
a
t
i
o
n
s
f
i
c
a
t
i
o
n
s
39 cm
57 cm
26 cm
19.5 kg
5
s
s
TRS, line-level output jack is
designed
to
feed
Acoustasonic Junior's effects bus
to an external signal pro c e s s i n g
device, such as a digital delay or
a
chorus
unit.
Acoustasonic Junior, the tip is left
and the ring is right.
can also be used as a line out.
inch, unbalanced, input/output,
line-level phone jack is designed
for use with a signal processing
device, such as a digital delay or
reverb unit. A special "Y" line cord
(stereo to dual mono) is required to
use this TRS jack (Ti p = S e n d ,
Ring=Return, Sleeve=Ground).
022-1332-000 (240V, 50 Hz) Aust
022-1362-000 (230V 50 Hz) Eur
the
On
the
This jack
Publicidad
