Shure N35S Guia De Inicio Rapido

Stylus removal and replacement
Remove and replace the stylus as shown above.
Always hold the stylus by the plastic grip. Do not
touch or damage the diamond tip or cantilever. Do
not force.
1. Mount your cartridge correctly in the tonearm and insert the stylus correctly into the cartridge.
2. Align your cartidge using the overhang tool supplied with your turntable or using an alignment protractor.
Set tracking force according to the table below.
3. Protect the stylus by carefully lowering the stylus guard when cleaning or dusting your turntable.
4. For automatic turntables, adjust the set–down position to prevent the stylus from striking the edge of the
record or turntable platter.
5. Use your tonearm's cuing device and avoid handling tonearm.
6. With manual cuing, grasp tonearm lightly and release as soon as stylus makes contact with the record.
7. Periodically check and adjust all tonearm settings. Use the Shure SFG-2 tracking force gauge for accu-
rately setting tracking force.
This Shure replacement stylus will restore your Shure cartridge to its original specifications and performance
level. Non–Shure styli are not recommended because they will compromise the performance of your cartridge,
cause mistracking and damage your records.
S
Polished, natural diamont stylus tip
S
Spherical radius: 18 µ (0.0007 in.)
Stylus Stylus Color
N35S Fluorescent
Yellow
N70BX Beige
SS35S Light Blue
PATENT NOTICE: Manufactured under one or more of the following U.S. Patents: 4,275,888; 4,441,177;
4,489,442.
Shure Incorporated ("Shure"), 222 Hartrey Ave-
nue, Evanston, Illinois 60202–3696, warrants to
the owner of this product that it will be free in nor-
mal use of any defects in workmanship and materi-
als for a period of one year from date of purchase.
You should retain proof of date of purchase. Shure
is not liable for any consequential damages. If this
Shure product has any defects as described
Copyright 2000, Shure Incorporated
27A3072 (TB)
Remove
Replace
TO PRESERVE STYLUS LIFE
USE ONLY SHURE REPLACEMENT STYLI
PRODUCT SPECIFICATIONS
Stereo Output (1
KHz at 5 cm/sec
peak recorded
velocity)
5.0 mV
5.0 mV
5.0 mV
WARRANTY
Models N35S, SS35C, N70BX
Replacement Styli
Stylus Cleaning
Use a soft brush with alcohol or an alcohol-distilled
water solution. Commercial cleaning solutions
may cause stylus damage. Brush only from back
to front as shown here, never fromt to back or side
to side.
S
Channel balance within 2 dB
S
Channel separation: 20 dB at 1 kHz
Frequency Tracking
Response in force range
Hz (grams)
20 to 20,000
20 to 18,000
20 to 20,000
above, carefully repack it and send it prepaid to: Shure In-
corporated, Attention: Service Department, 222 Hartrey
Avenue, Evanston, Illinois 60202–3696.
United States, return the product to your dealer or Autho-
rized Service Center for repair. The product will be repaired
or replaced and returned to you promptly. If it cannot be re-
paired or replaced, you may elect to receive a refund. This
warranty does not include stylus wear.
Typical
Tracking
Force (grams)
3–5 4
1.5–3 2
4–5 4.5
Outside the
Printed in U.S.A.