Merik 893MAX-LMK Manual Del Usario

Compatible with 315 MHz or 390 MHz garage door openers
manufactured after January 1, 1993. Make sure the garage door
opener has a working light bulb because it is a programming
indicator.
For use with gate operators, commercial door operators, or other
products that are 315 MHz or 390 MHz and have a Learn button.
Refer to your product manual for the location of the Learn button.
PREPARE
PROGRAMMING THE REMOTE CONTROL
1
To enter programming mode, press the Program button
until the LED on the front of the remote control turns on.
Visor Clip
4
To exit programming mode, press
any remote control button except
the button that was just programmed.
Locate the Learn
button on the garage
door opener.
NOTE: Your garage door
opener may look different.
OR
Learn
LED
Learn
LED
Green
or
Purple
Red/Orange
2
LED
The Learn LED will light.
5
To test, press the programmed button on
the remote control...
LED
OR
Learn
LED
Yellow
Press and release the
Learn button on the
garage door opener.
Within 30 seconds...
The garage door opener
will activate.
3-BUTTON REMOTE CONTROL
MODEL 893MAX-LMK
To prevent possible SERIOUS INJURY or
DEATH from a moving gate or garage door:
• ALWAYS keep remote controls out of reach
of children. NEVER permit children to
operate or play with remote controls.
• Activate gate or door ONLY when it can be
seen clearly, is properly adjusted and there
are no obstructions to door travel.
• ALWAYS keep gate or garage door in sight
until completely closed. NEVER permit
anyone to cross path of moving gate or
door.
Locate the Program button on
the remote control.
Program Button
3
Press and release the remote control button
you want to use...
Check to see if the garage
door opener light bulb
blinks.
If not, wait for the remote
control LED to light solid
then slowly press and
release the remote
control button again.
Repeat until the
light bulb blinks.
DO NOT press the
button after the light
bulb blinks.
6
Install the visor clip.