Publicidad
Idiomas disponibles
Idiomas disponibles
Introduction
Thank you for purchasing the Atlantic CSEAL15 Cord Seal Fitting (CSF), the unique, easy,
invisible solution to hiding unsightly power cords in water basins. Before using the Fitting
please take a moment to review this manual.
Assembling the Cord Seal Fitting around cord
The Cord Seal Fitting works with cords from 1/ 8 " to 3/ 8 " diameter. Begin by loosening the four
stainless steel screws of the CSF to disassemble the fitting. Slip the rubber core over the cord,
then loosely reassemble the fitting making
sure the splits in the top and
bottom plates are NOT
aligned, but perpendicular
to each other. Loosely install
the four screws to hold all components
together until installation is complete.
Through the Wall - Single Cord Seal Fitting
The Cord Seal Fitting is designed to be used in any standard 1½" Sch40 PVC socket. A 1½"
Male Thread x Slip Adapter is included to adapt to any 1½" FIPT fitting. If adapter is to be
used, install it first, using thread sealant.
Pass the cord through the adapter
and insert the CSF into the 1½"
socket. Alternate tightening
opposite screws to snug the
rubber core around the cord
and into the socket.
ATTENTION: Uneven tightening can impair CSF function, causing leakage or even
damage to the fitting. Be sure to tighten opposing screws, alternating between the two
pairs, a little at a time until the screws are evenly tightened, the fitting is snug and the
cord resists a gentle tug.
Through the Plumbing - Double CSF Install
When a single active water line is the only inlet or outlet of a tank or basin,
two Cord Seal Fittings will allow the cord to share the water line that
passes through the wall of the basin. This is common when there
is only one perforation in the reservoir wall, for the line from the
pump up to a spillway or other return. With the basin drained,
install one tee in the line on one side of the basin wall and
another tee on the other side. Run the cord through one tee
and out the other. Assemble two Cord Seal Fittings into
each of the tees as described above.
Warranty
This product carries a one-year warranty. This warranty is extended solely to the original
purchaser commencing from the date of original purchase receipt. Misusing or abusing
product voids this warranty.
Warranty Claims
In case of warranty claims, the Cord Seal Fitting should be returned to the place of
purchase accompanied by original receipt.
2
Publicidad
