Operating Mode - Lanaform Hydro Care Manual Del Usario

• Keep the device and cable away from heat, blunt objects or any element likely to cause damage.
EN
• Remove all particles from the vent holes and do not cover the device.
• Never drop and never insert objects in the holes.
• To disconnect the unit, make sure the device is turned off, then unplug from the power outlet.
• Always let the bath mat dry before storing.
• Do not use outdoors. This device is intended for inside use only.
• Use this apparatus only following the indications of this booklet.
• If the power cord is damaged it must be replaced by the manufacturer, an approved repair company or by any qualified
person, to avoid all risks.
WARNINGS
1. Non foaming bath oils and mineral salts can be used; please test first a small amount and then increase the quantity
progressively if necessary.
2. Use the bath mat only for its intended use, as described in the present guide.
3. If you suffer from a pathological condition such as varicose veins, certain skin disorders, etc, or if you are pregnant,
please consult your doctor before any use of this device.
1. REMOTE CONTROL COMPONENTS
A: Power adjustment button
B: On/Off button
C: Time adjustment button
D. Program adjustment button
How to change the remote control's batteries
The remote control works with a flat type CR2032 3V battery
(provided with the device).

Operating mode:

• To change the battery, please use a flathead screwdriver (not provided)
with good breadth.
• Place the tip of screwdriver in the slit located at the back of
the remote control.
• Turn your screwdriver counter clockwise so that the triangle facing
the symbol representing a closed padlock is in front of the opened
padlock symbol.
• Remove and change the battery, reverse steps to close
the battery compartment.
2. MAIN UNIT COMPONENTS
E: Power adjustment button (Hi, Med, Lo)
F: Time adjustment button (10-15-20-30-60 minutes)
G: Program adjustment button (P1-P2-P3-P4)
H: On/Off button
4