Samsung SmartThings Wifi ET-WV525 Manual Del Usuario página 7

Getting started
2
Connect the adapter to the Wi-Fi hub.
The Wi-Fi hub will turn on and the indicator light will flash green.
Use only Samsung-approved adapters (12 V/2.1 A or higher).
• Y ou can use the Wi-Fi hub only when you connect the Wi-Fi hub to an adapter.
• I f the Wi-Fi hub overheats for a prolonged period, the Wi-Fi hub may automatically
turn off or reset. When this happens continually, disconnect the adapter from the
Wi-Fi hub and contact a Samsung Service Center.
• T o save energy, unplug the adapter when not in use. The adapter does not have a
power switch, so you must unplug the adapter from the electric socket when not in
use to avoid wasting power. The adapter should remain close to the electric socket
and be easily accessible while using it.
Mobile device
3
Launch the SmartThings app on the mobile device.
4
Follow the pop-up window's instructions to turn on the Wi-Fi and Bluetooth auto on
feature.
When you launch the SmartThings app, the Wi-Fi and Bluetooth features will be
automatically activated.
5
The Wi-Fi hub will be detected automatically. Tap ADD NOW.
If the Wi-Fi hub is not detected, tap Add device on the dashboard. Then, tap
ADD DEVICE MANUALLY →
During setup, get within 15 ft of the hub.
6
Enter a network name and password to assign to the Wi-Fi hub.
To connect the Internet of Things (IoT) devices via the Wi-Fi hub, select the Wi-Fi hub
under devices and make sure the SmartThings Hub is switched on.
Wi-Fi Hub, and tap your Wi-Fi hub's name.
English (USA)
7
5
under