SPECIFICATION
Peak Power (watts)
Rated Power (watts
Frequency Response
Impedance
Sensitivity
Cone Material
Tweeter
Mounting Depth
Mounting Diameter
Peak Power (watts)
Rated Power (watts)
Frequency Response
Impedance
Sensitivity
Cone Material
Tweeter
Mounting Depth
Mounting Diameter
INSTALLATION GUIDELINES
Ensure the audio system is turned off before making any connections to the amplifier, speakers or
source unit. Failure to do so could result in permanent damage to the audio system.
When wiring the speakers ensure that the wire is protected from sharp objects and always use rubber
grommets when wiring through metal panels. Ensure all terminals and connections are protected from
the vehicle chassis and from each other as failure to do so could result in permanent damage to the
audio system.
When connecting the speakers to the source unit or amplifiers ensure you connect the positive and
negative output wire from the source unit to the corresponding speaker terminals. This will ensure the
audio system will be in phase.
1. Ensure there is adequate clearance and depth for the speaker to be mounted.
2. Use the supplied template to mark out & cut the correct diameter hole.
3. Drill four holes for the mounting screws.
4. Separate the grille from the frame
5. Insert the speaker and grille and affix with the screws provided
6. Complete installation by replacing the grille into the grille frame.
© 2017 Phoenix Gold • www.phoenixgold.com
Z4CX
120 Watts
30 Watts
99Hz-20KHz
4 Ohm
86dB
Polypropylene
PEI
43mm (1-11/16")
103 mm (4-1/16")
Z46CX
120 Watts
30 Watts
120Hz-20KHz
4 Ohm
87dB
Polypropylene
PEI
50mm (2")
142mm x 89mm
181mm x 128mm
(5.59" x 3.50")
Z-Series Coaxial Speakers
Z5CX
140 Watts
35 Watts
78Hz-20KHz
4 Ohm
86dB
Polypropylene
PEI
44mm (1-3/4")
46mm (1-13/16")
118mm (4-5/8")
Z57CX
140 Watts
35 Watts
71Hz-20KHz
4 Ohm
87dB
Polypropylene
PEI
56mm (2.25")
155mm x 222mm
(7.12" x 5.04")
Z65CX
160 Watts
40 Watts
75Hz-20KHz
4 Ohm
87dB
Polypropylene
PEI
126mm (5")
Z69CX
220 Watts
55 Watts
85HZ-20KHz
4 Ohm
88dB
Polypropylene
PEI
70mm (2.75")
(6.10" x 8.74")