Samson 366060.300 Manual Del Usuario página 2

The meter can be connected to a control gun or installed
directly in the distribution line pipe.
It is recommendable to install a cut-off valve before the
meter to facilitate its maintenance or repair.
The meter has a 3/4" BSP connection at the inlet and outlet.
Connection for the range of guns and original SAMSON
1
4 3
The meter shows the charging status of the batteries on
the display.
BATTERIES OK
2
836 852 R. 04/17
Samson Corporation • One Samson Way • N.C. 28778 Swannanoa USA • Phone (828) 686-8511 • Fax (828) 686-8533
Installation
accessories can be achieved by means of a bonded seal.
The meter requires two 1.5 V batteries and size LR 03 as the
power supply source. They are housed in a support which,
in conjunction with the lid design, prevents the batteries
from being removed accidentally in the event of impacts or
vibrations.
Batteries
ATTENTION: The meter is supplied without the batteries
mounted. Follow the procedure below to install them.
1. Loosen the screws (1) and remove the battery housing
2
2. Install the provided batteries (3) checking that the polarity
3. Put in place the cover (2) and tighten the screws (1).
T
o guaranTee The baTTery cover sealing
When replacing the batteries the monitor briefly displays
the meter software version.
Charging status of the batteries
If the meter does not switch on when pressing the ON/
RESET button, or switches off after being pressed, replace
the batteries with new ones.
BATTERIES HALF CHARGED
cover (2).
matches the polarity symbols (4) marked in the housing.
WARNINGS
is properly posiTioned and The screws TighTened
BATTERIES EMPTY
REPLACE THE BATTERIES
,
ensure ThaT The baTTery
.