Connection To The Mains; Rotor Positioning; Operation - Selecta CENTRONIC BLT Manual De Instrucciones

INSTRUCTION MANUAL CODE 80315 REV B
Make sure to fit the pin of the motor
shaft in its housing.
PROGRAMACIÓN
AJUSTES
PROGRAMMING
SETTINGS
TRABAJO
TASK
J
.P. SELECTA s.a.u.
Octubre 2019
6.3

Connection to the mains

Make sure that the equipment is connected to the mains and that the voltage coincides
with the indicated on the features plate.
Do not use an equipment without being earthed.
Only use the supplied cable for network connection.
6.4

Rotor positioning

Before starting the centrifuge, ensure that you have placed the rotor in a proper way,
otherwise it could cause damages on the equipment.
Firmly tighten the nut of the rotor with the
provided key (only for models Centronic
BLT, Centrofriger BLT and Mixtasel BLT).

7 Operation

All the functions of this equipment are set by the touch screen panel. Softly press
with the finger in the centre of each icon, and the action will be performed when
releasing the finger from the screen.
When starting the equipment, the starting screen is displayed.
Settings:
•
- Time and date: menu to set date and time.
• Programming:
- Enables programming the centrifuge profile, by defining speed, time and
acceleration and deceleration ramps.
Task:
•
- Enables selection and implement a centrifuge profile.
Ctra. NII Km 585.1 Abrera 08630 (Barcelona) España
e-mail: selecta@jpselecta.es - website: http://www.jpselecta.es
(It can be modified without notice)
Place the adapters and tubes evenly.
Tel 34 937 700 877 Fax 34 937 702 362
Page: 13