Storing The Trimmer; Environmental Protection - Cramer 2100886 Manual Del Usuario

SPOOL REPLACEMENT See Figure 9.
Use original manufacturer's replacement cutting line for
best performance.
„ Remove the battery pack.
„ Push in tabs on side of spool cover.
„ Pull spool cover up to remove.
„ Remove the coil protection from the old spool, and
install it on the new spool. Make sure the end of
the cutting line is extended from the slots of the coil
protection.
„ Install the new spool so that the cutting line and slot
align with the eyelet in the cutting head. Thread the
cutting line into the eyelets.
„ Reinstall the spool cover by depressing tabs into slots
and pushing down until spool cover clicks into place.
CUTTING LINE REPLACEMENT See Figures 10.
„ Remove the spool from the cutting head.
NOTE: Remove any old cutting line remaining on the spool.
„ Cut two pieces of cutting line approximately 3m long.
„ Insert one string into the anchor hole in the upper part
of the spool while the other string into the anchor hole
in the bottom part of the spool.
„ Wind the lines
simultaneously, as shown by the arrows on the spool.
„ Position the lines in the guide slots.
„ Install the coil protection on the spool. Make sure the
end of the cutting line is extended from the slots of the
coil protection.
„ Place the spring in the trimmer head with its small end
upward. Place the spool in the trimmer head. Insert the
ends of the lines through the line exit holes in the sides
of the trimmer head.
„ Reinstall the cover onto the trimmer head. Push until
cover snaps into place.
English (original instructions)
clockwise around the

STORING THE TRIMMER

„ Remove the battery pack from the trimmer before
storing.
„ Store it in a place that is inaccessible to children.
„ Keep away from corrosive agents such as garden
chemicals and de-icing salts.
„ Store and charge your batteries in a cool area.
Temperatures
temperature will shorten battery pack life.
„ Store the battery pack where the temperature is below
27˚C and away from moisture.
„ All batteries gradually lose their charge. The higher the
temperature, the quicker they lose their charge. If you
store your unit for long periods of time without using
it, recharge the batteries every month or two. This
practice will prolong battery pack life.
„ Secure the trimmer during transport to prevent damage
or injury. Clean and maintenance before storage, use
of guards on cutting attachments with metal blades.
Use of cover for metal blades during transport and
storage.

ENVIRONMENTAL PROTECTION

„ Environmental protection should be a priority of
considerable importance when using the machine,
for the benefit of both social coexistence and the
spool
environment in which we live. Try not to cause any
disturbance to the surrounding area.
„ Scrupulously comply with local regulations for the
disposal of packaging, deteriorated parts or any
elements with a strong environmental impact; this
waste must not be disposed of as normal waste, it must
be separated and taken to specified waste disposal
centres where the material will be recycled.
„ Scrupulously comply with local regulations for the
disposal of waste materials after mowing.
„ At the time of decommissioning, do not pollute the
environment with the machine, but hand it over to a
disposal centre, in accordance with the local laws in
force.
4
above or below normal room