Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
8
A
8A
B
8G
8F
8E
8D
C
OPTIONAL
8J
8H
8 OUTLET CONNECTOR INSTALLATION
A. Place Wax Seal (8A) firmly into groove on the base of Outlet Connector (8B) as shown.
B. Place Outlet Connector (8B) onto Waste Outlet Hole (8C) with Tee Bolts (8D) passing
through Fixing Holes (8E). Place Washers (8F) and Nuts (8G) into Tee Bolts (8D).
Secure Outlet Connector (8B) by tightening Nuts (8G).
C. Optional: For additional support, mark and drill a second set of Mounting Holes (8H)
and install Screws, Washers and Anchors (8J) that are provided.
8B
8B
8G
8F
8E
8D
8C
8J
8B
8H
ENGLISH
9
9B
9A
9J
9H
9L
9K
9 TANK INSTALLATION
The tank comes pre-installed with flushing mechanism. Attach Large Hose Nut (9A) to
Fill Valve Shank (9B) located on bottom of Tank (9C). Insert Rubber Gasket (9D) into
Water Inlet Hole (9E) on top of Bowl Shelf (9F). Place Tank (9C) on top of Bowl Shelf
(9F) and align Brass Bolts (9G) and insert Hose (9H) through corresponding Shelf
Holes (9J). From underneath bowl, screw Locking Nuts (9K) and Washer (9L) onto
Brass Bolts (9G) and tighten.
Do not over tighten!
3
For E11W Models
Continue With Step 9
For E10W Models
GO To Step 10
9C
9G
9D
9E
9F
Publicidad
Tabla de contenido
