Important Safety Regulations - Newa NLD Instrucciones Y Garantía

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 25
EN-
EN

IMPORTANT SAFETY REGULATIONS

This appliance is intended for use in a fresh or marine water
aquarium in homes. Any other use is not permitted and
therefore the manufacturer shall not be held liable. NEWA LED
complies with current EU safety regulations (EN60598-2-11).
The NEWA LED has been designed and made in compliance
with the directives 2014/30/EU and 2014/35/EU in order to
guarantee safe use throughout its life cycle. Nevertheless,
improper use of the product (use not compliant with the
provisions of this manual) may cause damage to the aquarium
and compromise user safety.
WARNING: the symbol on the label indicates that
you must thoroughly read this operating instruction
manual before starting up, operating or carrying out any
maintenance operations on the appliance.
WARNING: during installation and maintenance,
disconnect the aquarium and all its accessories from the
electrical mains. To avoid any kind of accident, carefully
follow the simplest safety provisions and the following
warnings:
1) CAUTION: This appliance can be used
by children aged from 8 years and above
and persons with reduced physical,
sensory or mental capabilities or lack of
experience and knowledge if they have
been given supervision or instruction
concerning use of the appliance in a safe
way and understand the hazards involved.
Children shall not play with the appliance
because this is not a toy. Cleaning and
user maintenance shall not be made by
children without supervision.
2) WARNING: turn off and disconnect all
the electrical equipment in the aquarium
before carrying out any maintenance
tasks.
3) The power cord must not be repaired
or replaced. If it is damaged, replace the
entire appliance.
4) Read the warnings and observe the symbols on the labels
of all electrical appliances and in the instructions.
5) Fill the tank always making sure that the water level is 15
mm at least from the upper rim; see the symbol
on the product label.
6) Check that the voltage printed on the label matches the
one of the power supply.
7) WARNING: during functioning never stare at the
luminous source, see symbol on the appliance
.
It is recommended to switch the lamp off during
maintenance.
8) The power supply cable should be inserted in the socket
10

Publicidad

Tabla de contenido
loading

Tabla de contenido