Operation And Maintenance; Pre-Filter Flushing (Initial Setup, Before Installing Ro Element); Filter Maintenance; Filter Replacement - Genpar NURFILTER Blue Tide Manual De Instalación Y Mantenimiento

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Operation and Maintenance

Pre-filter Flushing (initial setup, before installing RO Element)

• Prepare system for operation by flushing pre-filters:
• Disconnect RO element inlet tube on element housing cap. Open water main and inlet valve and allow system to run
through the 3 pre-filters.
• Discard output water into container or drain.
• Continue flushing until output water is visibly clean. Reconnect tube.
Pump and membrane may be severely damaged if system is run without flushing pre-filters. Discard all water from
Note:
flush, it is not suitable for use or consumption.
• After flushing pre-filters connect and open all valves.
• Wait approximately 2 minutes before opening faucet.
• Allow system to flush for first 10-15 minutes with faucet open. After flushing the system is ready to use.

Filter Maintenance.

To ensure the unit operates at its optimum level, routine maintenance is required. The frequency of maintenance depends
on the feed water quality, The follow are some guidelines for scheduled filter changes, keep in mind the frequency of filter
changes may vary. If in doubt, contact your local dealer or service technician.
• Change Spun PP Filter every 3-6 months or as required.
• Change Granular Carbon Filter and Block Carbon Filter every 6-12 months or as required.
• Change RO Membrane every 18-24 months or as required.
• Change Inline Carbon Filter every 6-12 months or as required.
If you will be away or not using the unit for an extended period of time, please disconnect unit from power supply. If the
unit has been shut down and not used for an extended period of time, perform the same flushing procedure as in the
initial set-up.

Filter Replacement

9
+1-503-GENPAR-6 - www.mygenpar.com
Prepare a housing wrench
Turn off feed water valve
Put there placement filters in the
housing sand double o-ring
. Be sure to
tighten with
o-ring to prevent
from leaking.
Turn on Feed Water Valve
and Faucet
Genpar Industries LLC USA

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido