Descargar Imprimir esta página

Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

globalindustrial.ca
Assembly Instructions
Customer Service
US: 1-800-645-2986
Read and understand all instructions and safety warnings prior to operating jack. Operators must be qualified, trained, and use caution when operating unit.
All parties must follow proper safety procedures and precautions at all times.
Use only on level, durable surfaces away from traffic.
The forklift jack should only be positioned under the forklift in areas specified by forklift manufacturer.
Do not exceed rated capacity of 8800 lbs.
Apply parking brake and chock tires prior to raising forklift.
Inspect jack prior to use; do not operate if damaged or in poor condition.
Use extreme caution when lifting narrow fork lift trucks (less than 40" wide).
Never use more than one jack to raise fork lift truck.
Do not raise forklift from ground completely, two wheels must remain in contact with floor at all times.
Do not insert jack beyond red line on marked decal on lift arm surface.
Do not mishandle or abuse unit in any manner.
Do not operate, move or dolly forklift when supported by jack.
Use appropriate support stands to stabilize forklift when raised. Do not service or work under forklift for any reason unless properly supported.
Jack is solely designed for fork lift truck handling.
Do not modify or alter unit. Modifications may cause improper functionality resulting in possible injury or death.
Do not operate unit with ANY aftermarket accessories including but not limited to lift pads, adaptors or devices.
Wear safety approved eyewear and gloves while operating jack. Protect all extremities including hands, feet and other body parts while operating
or transporting jack.
Operate unit slowly, remaining clear of load while in motion.
The warnings, precautions and instructions discussed cannot cover all possible conditions and situations that may occur.
Failure to heed these warnings may result in property damage, personal injury and/or death.
Instrucciones de Ensamblaje
Servicio de atención al Cliente
México: 01.800.681.6940
Forklift Jack
Model 988869
Manual Forklift Jack Safety Warnings #988869
Distribucion Industrial Globales S DE RL DE CF
Directives d'assemblage
Ref.
Qty.
1
2
3
Rated capacity
Starting pad height (notch)
Max, raised height
Width
Weight
1
Service à la clientèle
Canada: 888-645-2986
CONTENTS
Description
1
Jack Assembly
1
Jack Handle
1
Quick release locking pin
SPECIFICATION
4000 kg./8800 lbs.
65mm (2-1/2) inches)
406mm (16 inches)
200mm (7-7/8 inches)
32 kg. (70 lbs.)
080516

Publicidad

loading

Resumen de contenidos para Global 988869

  • Página 1 Weight 32 kg. (70 lbs.) Manual Forklift Jack Safety Warnings #988869 Read and understand all instructions and safety warnings prior to operating jack. Operators must be qualified, trained, and use caution when operating unit. All parties must follow proper safety procedures and precautions at all times.
  • Página 2 Forklift Jack Instruction Manual Align holes and insert locking pin 080516...
  • Página 3 Forklift Jack Instruction Manual TRANSPORTING BY WHEEL First raise jack handle as far as it will go and place "J" clip around the pump shaft as shown. This will prevent the handle from moving down. Push down on the handle to raise the front foot pad off the floor and allow the jack to roll freely on its wheels.
  • Página 4 Forklift Jack Instruction Manual PRESSURE RELEASE KNOB To lower jack, slowly turn knob counter clockwise until desired height is reached then slowly release knob. TWO POSITION LIFT PAD To Lift by Frame Edge For Flat Surface TO RAISE JACK Crank handle in an up and down stroke 080516...
  • Página 5 Peso 32 kg. (70 lbs.) Advertencias de Seguridad del Gato de Carretilla Elevadora Manual #988869 Lea y entienda todas las instrucciones y advertencias de seguridad antes de operar el gato. Los operadores deben ser calificados, entrenados y tenga cuidado cuando lo opere.
  • Página 6 Gato de Carretilla Elevadora Manual de Instrucciones Alinee los agujeros e inserte el pasador de seguridad 080516...
  • Página 7 Gato de Carretilla Elevadora Manual de Instrucciones TRANSPORTE CON RUEDAS Primero levante la manija del gato hasta donde se pueda y coloque el clip en "J" alrededor del eje de la bomba como se muestra. Esto evitará que la manija se mueva hacia abajo. Empuje hacia abajo la manija para levantar la almohadilla delantera del pie del suelo y permita que el gato ruede libremente sobre sus ruedas.
  • Página 8 Gato de Carretilla Elevadora Manual de Instrucciones PERILLA DE LIBERACIÓN DE PRESIÓN Para bajar el gato, lentamente dé vuelta a la perilla hacia la izquierda hasta la altura deseada y lentamente libere la perilla. ALMOHADILLA DE ELEVACIÓN DE DOS POSICIONES Para levantar por el Para Superficie borde del Marco...
  • Página 9: Vérin De Chariot À Fourches

    Poids 32 kg (70 lb) Avertissements de sécurité du vérin manuel de chariot à fourches #988869 Lire et comprendre toutes les instructions et les avertissements de sécurité avant d’utiliser le vérin. Les utilisateurs doivent être qualifiés, formés, et faire preuve de précautions en utilisant l’unité.
  • Página 10 Vérin de chariot à fourches Directives d’utilisations Aligner les trous et insérer la goupille de sûreté 080516...
  • Página 11 Vérin de chariot à fourches Directives d’utilisations TRANSPORT SUR ROUE Soulever d’abord la poignée du vérin aussi loin que possible et placer une attache en « J » autour de l’arbre de pompe, comme indiqué. Ceci évitera à la poignée de se déplacer vers le bas. Pousser sur la poignée vers le bas pour soulever le pied avant du sol et permettre au vérin de rouler librement sur ses roues.
  • Página 12 Vérin de chariot à fourches Directives d’utilisations BOUTON DE RELÂCHEMENT DE LA PRESSION Pour abaisser le vérin, tourner le bouton en sens antihoraire jusqu’à la hauteur désirée, puis relâcher lentement le bouton. PATIN DE LEVAGE À DEUX POSITIONS Pour lever par le bord Pour une surface du châssis plane...