NIPPON SIGMAX ZAMST JK BAND Instrucciones De Uso página 2

How to apply
• Before attaching this product, carefully read the "Precautions for use - Be sure to read this" section. Then follow the steps provided to ensure the
product is correctly attached.
• The steps below use the right leg for reference. Follow the same steps for the left leg.
1.
Unfasten all the hook-and-loop fasteners of the product. Confirm the top/bottom and inside/outside of the product.
Hook-and-loop fastener A
<Outside of the product>
2.
Place the product on your knee.
3.
Fasten hook-and-loop fastener A.
Hook-and-loop
fastener A
4.
Fasten hook-and-loop fastener B.
Hook-and-loop
fastener B
5.
Make sure that the product is not loose or out of place. If you feel any discomfort, repeat the steps from the beginning to
reattach the product.
Disclaimer:
* The product specifications and appearance are subject to change without notice for the purpose of improvement.
* When disposing of this product, be sure to follow all disposal ordinances and regulations as specified by the local government.
* We take all possible measures to ensure product quality, however, if you find any defects, etc. in our products, please contact Nippon Sigmax Co., Ltd.
"ZAMST" and "ZAMST logo" are trademarks or registered trademarks of Nippon Sigmax Co., Ltd in Japan, the United States and other countries.
Hook-and-loop fastener B
Position of
patella
Position of
patella
Position of
PT pad
The product correctly fastened (right leg)
<Front view>
Tag PT pad (internal)
<Inside of the product>
Place it on your knee so that PT pad is just below your patella
(patellar ligament).
Fasten hook-and-loop fastener A while pulling the product.
Make sure that the PT pad is just below your patella.
Fasten hook-and-loop fastener B by pulling the product.
The compression level can be adjusted by pulling the product.
Adjust the product to create the required compression.
<Side view>
Place the side with the size tag on the back
of the product face up when applying it to
your knee. Confirm the vertical positioning of
the product by checking the direction of the
arrow on the tag.
<Back view>