Scorpion Sports EXO-410 AIR Manual Del Usuario página 9

FaceShield Replacement
To remove your faceshield, place the helmet in front of you with the eye
port facing away. Ratchet the faceshield up to the fully open position.
Using both hands, push up the Y shape release latchet upward and the
shield is able to release out of locking mechanism. Than, with both of your
thumbs pushing squarely on the center of the Ellip-Tec™, gently pull or
"peel" the faceshield away from the helmet.
RATCHETING SYSTEM
Securing and Wearing your Helmet
While you are wearing your helmet, grasp the notched arm of the
chinstrap with your right hand, and the locking mechanism with
your left hand. Pull the nylon tab with your thumb and forefinger to
open the locking brace. Insert the notched arm into the slot. Release
the nylon tab to lock the arm in place. Adjust as needed.
IMPORT NOTE:
Be sure to latch up
the "y" release
latchet while
removing
raceshield!
None of the components of your ScorpionExo helmet can be damaged by
water. All headliners and seat-wicking cheek pads are machine washable.
Wash them with a mild detergent in warm water and allow to air dry. Hand
washing is recommended, but machine washing is also permitted. Use the
"delicate" cycle to prevent the agitator from damaging the
Using your chinstrap
Nylon tab
Locking brace
Open slot
Notched arm
Cleaning Your Helmet System
EN
FIRMLY AND SECURELY
FASTEN YOUR CHINSTRAP.
Check your chinstrap for
tightness occasionally as
vibration or wind may
loosen it.
8