Sleep Function; Troubleshooting - QFX SNOOZE CR-30 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

4. Press the CLOCK / MEMORY button (2) to set the current Radio Station to the selected
preset shown on the LED Display.
5. Repeat steps 1-4 to set additional presets into the memory.
To tune directly to your Radio Presets simply press the CLOCK / MEMORY button (2)
repeatedly to cycle through the Presets stored in the memory.

SLEEP FUNCTION

This Alarm Clock can be set to play music for a set amount of time (10-90 minutes) and then
automatically turn OFF using the SLEEP Timer.
To turn the SLEEP Timer function ON simply press the SLEEP button (4) and "90" will
show on the LED Display indicating the music will automatically turn OFF after 90
minutes. To adjust the amount of time before the music will turn OFF, press the SLEEP
button (4) repeatedly until the correct amount of time (90 – 80 -70 – 60 – 50 – 40 – 30 –
20 – 10 minutes) is shown on the LED Display.
To turn the SLEEP Timer OFF continue pressing the SLEEP button (4) until the LED Display
shows "OFF".
BATTERY INSTALLATION FOR POWER BACKUP - Requires 2 AAA
Batteries (Not Included)
In case of a Power failure, the Battery Backup will keep the Clock & Alarm times accurate until
the main power has been restored.
During a power failure the LED display will remain OFF until power has been restored.
NOTE: Batteries are not required for normal use of this clock. The purpose of the Battery Backup
is to insure the correct Time & Alarm settings are stored in the Clock Memory in the event of a
power failure.
Open the Battery Compartment by gently pushing the tab on the compartment door in the
direction indicated on the bottom of the clock.
Insert 2 AAA batteries (not included) following the + / - polarity as indicated in the
compartment.
Replace the door to the Battery Compartment and make sure it properly clicks in place. NOTE:
Do not force the door as breakage may occur.

TROUBLESHOOTING

Symptom
Alarm did not sound
No sound
Time is Flashing
Possible Cause
Alarm was not properly
turned ON.
Alarm was not set to the
correct
Time (AM / PM)
Clock not in correct Function.
Volume set at minimum
- Power Loss
Solution
Check the LED Display
Lights
to insure the correct Alarm is
turned ON
Check the Alarm Time reset
as necessary
Press the FUNCTION button
(1) to the desired Function (
FM, AM).
Increase Volume.
- Reset the Time

Publicidad

Tabla de contenido
loading

Productos relacionados para QFX SNOOZE CR-30

Este manual también es adecuado para:

Cr-30

Tabla de contenido