Sunex Tools 9005A Instrucciones De Operación página 4

SPRAyINg
In normal use, the nozzle wings are
horizontal as shown here. This provides a
vertical fan-shaped pattern which gives
maximum, even material coverage as the
gun is moved back­ and forth parallel to the
surface being finished.
OPERATION
Proper handling of the gun is essential for obtaining a good finish. The
gun should be held at a right angle to the surface being covered, and
moved parallel with it. For precise control of the gun and material, the
trigger should be released before the end of the strok­e.
Hold the gun from 6 to 12 inches away from the surface depending
6 to 12 inches
Start
Pull
strok­e
trigger
RIGHT
9005A: Parts Breakdown & Operating Manual
Spray pattern may be infinitely adjusted
from round to flat.
Even and wet coat
Release End of
trigger Strok­e
Set inlet pressure at no more than 50 PSI. For optimum
performance, some materials may spray better at PSI
ratings below 50 PSI. If unsure, always test at PSI ratings before
using on final production. Try spray. If it is too fine, decrease
the air pressure or open fluid control screw. If the spray is too
thick­, close the fluid control screw. Regulate the pattern width
and repeat adjustment of spray as needed.
on material and atomizing pressure. For a uniform finish, lap each
strok­e over the preceding strok­e, mak­ing sure the spray is smooth
and wet.
Using the lowest possible atomizing air pressure will
overspray and provide maximum efficiency.
Light Coat
WRONG

Heavy Coat
reduce
rev. 05/7/06