Victron energy CAN-bus Manual Del Usuario página 9

Installation
Important!
Basic settings
When using the device f or the f irst time, the f ollowing basic settings must be applied:
Programming the threshold value
• Connect the CAN-bus temp sensor to an 800C/1600 using the CAN-bus cable
• Tick checkbox 80 and enter the desired parameters
• Click on "Send all settings to converter"
• No more than 4 seconds later, the green LED on the CAN-bus temp sensor will f lash 3 times to conf irm
Af ter starting up the 800C/1600 or af ter a reset, it will take no more than 4
seconds bef ore the CAN-bus temp sensor sends a CAN message to the converter.
Until a message has been received, the words "no signal" may be displayed in the
TSConf ig monitor window.
If the connection to the CAN-bus temp sensor is lost (due to a cable break), the 800C/1600
will indicate "no signal" no more than 12 seconds af terwards. If this happens, the
temperature threshold programmed in on the 800C/1600 will not be used
to limit the charging voltage.
Setting the CAN-bus temp sensor as a stand-alone module
If the CAN-bus temp sensor is being used as a stand-alone module, a temperature (alarm) threshold value
must be programmed f irst of all.
Programming a threshold value can only be carried out using an 800C/1600 and TSConf ig Sof tware.
Alarm
If the temperature has reached the threshold value (= converter of f ), the converter will be switched of f
(switching on will be blocked).
The block will not be lif ted until the temperature has risen above the alarm threshold f or a period of 5
minutes.
7