Braun Oral-B Oxy Jet 3D Center Manual Del Usuario página 9

Using the OxyJet
Before using for the first time, fill the water container and
allow the water to run through completely by holding the
irrigator handle over a washbasin.
1. Attach one of the irragtor jets to the handle until it locks
in place. Fill the water container with water and add
mouthwash, if desired.
2. Turn on the irrigator by pressing the on/off switch.
(When doing so, the sliding switch on the handle
should not be in its upper position.)
3. Select the water pressure with the pressure control
dial (1 = gentle, 5 = strong). We recommend that you
start with setting 1, especially if your gums tend to
bleed or if children are using the irrigator.
4. Bend over the washbasin and guide the jet to your teeth
and gums. Slide the handle switch up to start the water
stream. Keep your mouth slightly open to allow the water
to run into the washbasin.
You can choose between two different jet functions
by sliding the jet switch down or up (before doing so,
turn off the water stream by pushing the sliding switch
down):
Rotating stream for general cleaning and gum
massage (jet switch in lower position)
The rotation of the water stream and its micro-bubbles
is designed for easy penetration below the gumline.
Mono stream: straight water stream for site-specific
cleaning (jet switch in upper position)
Max. operating time: 15 minutes
Cooling off time: 2 hours
®
Irrigator
9