Publicidad
Idiomas disponibles
Idiomas disponibles
REASSEMBLE
4
4
1.
If you used auxiliary gas supply in LEAK TEST Step 1, re-
move the gas supply.
2.
Push refrigerator completely into enclosure.
3.
Put screws through mounting fl anges of refrigerator and into
refrigerator cabinet/wall.
4.
Attach door to refrigerator.
5.
Put screws through lower rear of refrigerator and into fl oor.
6.
Attach gas supply line of the RV to 3/8 inch male fl are fi tting
of refrigerator.
To avoid possible propane gas leaks,
WARNING
!
always use two wrenches to loosen and
ATTENTION
tighten gas supply line at manual shut off
valve of refrigerator.
Do not allow leak detecting solution to
WARNING
!
touch electrical components. Many liq-
ATTENTION
uids are electrically conductive and can
cause a shock hazard, electrical shorts,
and in some cases fi re.
7.
Test gas supply line of the RV for gas leaks after reinserting
in cabinetry.
8.
Connect DC wiring to refrigerator.
9.
Connect DC wiring to battery.
10. Connect AC power cord to receptacle.
11. Close lower intake vent.
12. Perform a fi nal Drop Pressure Test to complete the inspection
and repair.
A fi nal Drop Pressure Test is necessary
WARNING
!
ATTENTION
to ensure air quality of the entire coach.
2
www.norcold.com
Publicidad
