Connecting A Device For The First Time (Pairing); Playing Connected Devices - Naxa NPB-262 Manual De Instrucciones

Connecting a Device for the first
time (Pairing)
Before using a wireless device with Bluetooth, you
will need to establish a connection between it and the
Boombox. This process is called "pairing" and you will
only have to do it once. Once two devices are paired,
they will automatically connect when they detect each
other.
1. When you set the Boombox to Bluetooth mode and
it does not detect a paired device, it will automati-
cally switch to pairing mode. (The display will flash
"Bluetooth" and the blue "PAIR" indicator will blink
when the Boombox is in pairing mode.)
2. On your wireless device, go to its Bluetooth settings
menu.
3. Have your wireless device "search for devices". Se-
lect the boombox "NAXA NPB-262" when it is
found.
4. When pairing is complete, the Boombox will emit
a soft tone, the display will stop flashing, and the
Page 14
blue "PAIR" indicator will light a steady blue.
The boombox will automatically connect to your wire-
less device next time as long as it has Bluetooth en-
abled, is within range, and is set to be visible to paired
devices.
LL
There are many different Bluetooth en-
abled devices out there; we cannot provide
instructions for all of them. Please refer to
your device manufacturer's instructions
or website to learn more about connecting
with Bluetooth.

Playing Connected Devices

Control playback from your wireless device. The vol-
ume level may be controlled by the wireless device or
by turning the VOLUME dial [20].
Basic playback (such as play/pause, next, previous)
may also be controlled by the boombox and its remote
control if your wireless device supports it.
Naxa Electronics