Cleaning And Maintenence - MaxPro MPBBG150 Manual Del Usario

Instructions for use
Before switching on the machine, check if all screws and nuts are tight and if the grinding wheel can rotate
freely.
Always grind on the front part on the grinding wheel. Never overcharge the machine, causing the grinding
wheel to come to a halt.
The machine is not intended for permanent use. Make sure that the machine is not overheated.
After using the machine for 30 minutes, let it cool down to ambient temperature.
Switching on and off (fig. A)
To switch the machine on, set on/off switch (1) to '1'
To switch the machine off, set on/off switch (1) to '0'
Always pull out the mains power plug before starting any cleaning work.
Cleaning
<
Wipe the equipment with a clean cloth or blow it with compressed air at low pressure.
t

solvents; these could attack the plastic parts of the equipment. Ensure that no water can seep into the
device.
Carbon brushes
In case of excessive sparking, have the carbon brushes checked only by a qualified electrician.
Important! The carbon brushes should not be replaced by anyone but a qualified electrician.
Maintenance
There are no parts inside the equipment which require additional maintenance.
Do not dispose of electric tools, accessories and packaging together with household waste material
- in observance of European Directive 2002/96/EC on waste of electric and electronic equipment and its
implementation in accordance with national law, electric tools that have reached the end of their life
must be collected separately and returned to an environmentally compatible recycling facility
Fault Symptom
Electric motor out of
service
Sluggish start-up, falling
2
short of running speed
3 Excessive running noise
7
B B ench Grinder MPBBG150 User Manual

CLEANING AND MAINTENENCE

immediately each time you have finished using it.
cloth and some soft soap. Do not use cleaning agents or
ENVIRONMENT
TROUBLE SHOOTING
Possible Cause
Disconnection between plug and
power socket
Shortcircuit in power supply
At switch-off
Loose switching contact
Capacitor damage
Burnout of stator coil
Stator wiring disconnection
Wiring disconnection
Unsmooth running in mechanical
part
Burnout of switch contact
Capacitor damage
Low supply voltage
Electric motor at fault
Get stuck in mechanical driving
housing free of dirt and dust as far as possible.
Put plug in power socket
Repair and reconnection
Switch on
Replace switchboard by repairer
Replace capacitor by repairer
Replace stator by repairer
Reconnection by repairer
Check electric circuit connection by repairer
Check mechanical part by repairer
Replace switchboard by repairer
Replace capacitor by repairer
Regulate supply voltage
Check motor by repairer
Check mechanical part by repairer
GB
Troubleshooting