Dmx Linking - Iluminarc Colorist Line 12Qa Guía De Referencia Rápida

Colorist™ Line 12Qa QRG

DMX Linking

DMX Connection
IP65 DMX Cable
Table
IP65 DMX
Connector Pins
Control Panel
Description
Passcode
The Colorist™ Line 12Qa will work with a DMX controller using a
regular DMX serial connection. A DMX Primer is available from
www.iluminarc.com.
The Colorist™ Line 12Qa uses a regular DMX data connection for its
DMX personalities: 4-CH, 6-CH, 10CH, 48CH, and 53CH. See the User
Manual to connect and configure for DMX operation.
Connection
Ground
Data -
Data +
Male IP65 (DMX Input)
To connnect the Colorist™ Line 12Qa to your DMX network, it is
necessary to use the 3-pin to 5-pin adapters supplied with this
product.
When not using the Power Output, DMX Input or DMX Output
connectors, you must seal the cable ends with the supplied caps.
Button
Exits from the current menu or function
<MODE>
Enables the currently displayed menu or sets the currently
<ENTER>
selected value into the selected function
Navigates upwards through the menu list or increases the
<UP>
numeric value when in a function
Navigates downwards through the menu list or decreases
<DOWN>
the numeric value when in a function
After being prompted, enter the following passcode by pressing:
·
<UP>, <DOWN>, <UP>, <DOWN>, <ENTER>
This passcode cannot be changed and must be used whenever prompted.
DMX (U.S.) DMX (Europe)
Shield
White
Red
F
emale IP65 (DMX Output)
Function
4
IP65 Pin
Shield
Blue
Brown
EN
1
2
3