Fellowes POWERSHRED 225Ci Manual De Instrucciones página 4

PRODUCT MAINTENANCE
CLEANING AUTO-START INFRARED SENSORS
Paper detection sensors are designed for maintenance free operation. However, on rare occasions the sensors may become blocked by paper dust causing the motor to run
even if there is no paper present
TO CLEAN THE SENSORS
1 2
AUTO
Locate Auto-start
shredder infared sensor
OILING SHREDDER
empty your waste bin.
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
2
1
AUTO
Press and hold forward
*Apply oil across entry
( ) 2-3 seconds
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
PREVENTIVE MAINTENANCE & ACCESSORIES
TROUBLESHOOTING
A B
Go to Support Section at www.fellowes.com or see back page of manual for useful telephone numbers.
.
3 4
Dip cotton swab in
rubbing alcohol away any contamination
from the paper sensors
C D
A. Door Open Indicator:
door to resume shredding.
B. Bin Full Indicator:
waste bag 36054.
C. Remove Paper Indicator: When illuminated, press reverse (
D. SafeSense Indicator: If hands are too close to the paper entry, the SafeSense
®
and the shredder will stop shredding. If SafeSense
turn off and the user must press the power button on the control panel to resume shredding.
Self Cleaning Cycle: Shredder periodically cycles in forward and reverse lasting 3-6 seconds (225Ci only).
ENGLISH
Models 225Ci/225i
) and remove paper.
® indicator will illuminate
® is active for 3 seconds, the shredder will automatically
4