INTERSTEEL DIGITAL DOOR VIEWER 2.2 Manual De Usuario página 9

Operation instructions:
Vibration alarm function
The vibration alarm function is shut by default at the factory. The vibration
alarm function needs to be started by pressing the power button for 3
seconds when display turns on. The buzzer emits three beeps and a vibration
alarm icon appears in the lower right corner of the display, which
indicates that the vibration alarm function starts. To shut the vibration alarm
function needs to press the power button for 3 seconds when the display
turns on.The buzzer emits a long "drip" sound, the vibration alarm icon
disappears, which indicates the vibration alarm function shuts.
When the vibration alarm function starts, once the Digital Door Viewer
detects the vibration, it will trigger an alarm.After 10 seconds, the display
automatically turns on and emits a continuous alarm sound "Drip", and a red
alarm icon appears in the lower right corner of the display. After 10
seconds the Digital Door Viewer stops the alarm, shuts down and continues
keeping the vibration alarm monitoring state.
After the vibration alarm is triggered, the owner can cancel the alarm at any
time by short pressing the power button of the display.
Choose your auto-store file:
- Users can choose to save photos in local file or TF card.
- The default store is local file.
Memory Card Installation:
-
There is NO TF card included. This should be purchased by user
separately.
- Please insert the TF card before installing batteries.
- Before inserting the TF card, make sure the metal cover above the TF
card socket is pushed towards the OPEN mark.
- Lift and open the upper of the metal cover and insert TF card into the
metal cover.
- Then replace the metal cover and push back to LOCK mark.
- Max. 8GB TF card can be used, over HDSC Class 6 is suggested.