Draw-Tite Intella-Stop Xtreme Manual De Usuario página 2

Installation Guide
Mount your Intella-Stop™ Xtreme brake control in the
direction of travel and in a location where display is
viewable and buttons are easily accessible.
Wiring Brake Control
Your Intella-Stop™ Xtreme brake control has a unique
connector located at the back of the control. This
connector allows you two options to wire your
brake control.
Option 1:
Use Pigtail Wiring Harness included. This harness can
be installed by following the Generic Wiring Guide.
Option 2:
Use an OEM specific wiring harness. If your vehicle
came with a factory tow package that included a 7-way
connector, you can purchase a Towready™ OEM
wiring harness with the Intella-Stop™ Xtreme connector
on one end and your specific vehicle's connector on
the other.
Display Readings after Wiring the
Intella-Stop™ Xtreme
After successfully wiring your Intella-Stop™ Xtreme
you should see the following on the LCD display:
• Power to Intella-Stop™ Xtreme without
trailer connected.
• Power to Intella-Stop™ Xtreme with trailer connect-
ed Boost feature engaged (B1).
• Manual Knob Activated without trailer connected.
• Manual knob activated (with trailer), 5.4 denotes a
hypothetical power output. This value is set using
the Power Buttons. Range is 0.0 to 15 volts. This is
an indication of voltage output to electric brakes.
2
ALTERNATING SCREENS