Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly
Preparation: Before beginning assembly of product, make sure all parts are present. Compare parts with package
contents list and hardware contents above. If any part is missing or damaged, do not attempt to assemble the product.
Contact customer service for replacement parts.
Tools Required for Assembly (not included):
Phillips screwdriver with medium blade
1. Locate B/C/D and Door Panel with Door (F). Align hole in all panels
and insert M6x25 Bolts (AA), through M6 Washer (BB), then insert
Bolt/Washer through holes. Loosely tighten with Wrench A (CC).
Locate Cross Bar (L) and Back Panel (B), insert M6x25 Bolts (AA),
through M6 Washer (BB), then insert Bolt/Washer through holes.
Loosely tighten with Wrench A (CC).
DO NOT OVERTIGHTEN as you will need to adjust the panels to ensure
proper alignment.
Hardware Used:
AA
M6x25 Bolt
BB
M6 Washer
2. Attach Propane Tank Strap (II) to the bottom plate as shown in
Figure 2.
3. Open the Door and attach the Bottom Plate (E) to the assembled Side
Panels/Door Panel using M6x25 Bolts (AA) and M6 Washer (BB). Attach
the Cross Bar (L) to Bottom Plate (E) by using M6x25 Bolts (AA) and M6
L
Washer (BB),Loosely tighten with Wrench A (CC).
DO NOT OVERTIGHTEN as you will need to adjust the panels to ensure
A
proper alignment.
Hardware Used:
AA
M6x25 Bolt
BB
M6 Washer
NOTE: Right and Left
x 9
Panels (C/D) marked 1,
2 should match the door
panel with F marked 1, 2
x 9
A
B
C
D
K
x 5
J
E
F
x 5
A
B
C
L
D
K
J
E
F
I
H
G
1
2
II
HH
K
II
J
I
H
3
G
1-877-387-3639
II
|
Page 7
Publicidad
Tabla de contenido
