Installation Instructions - Merrychef Microcook MD Manual De Instrucciones

INSTALLATION
Remove packing material and protective film from the oven.
Check for obvious signs of transit damage. If necessary, inform the
supplier IMMEDIATELY.
LOCATION AND POSITIONING
Choose a site away from major heat sources.
DO NOT position so that hot air is drawn in from fryers, grills, griddles,
etc.
A heat barrier to the height of the oven must be installed if sited next to a
hob, stove or range.
Place the oven on a flat surface that is LEVEL, STRONG and STABLE.
Allow a minimum clearance of 50mm to the rear, top and each side to
allow air to circulate freely for each oven (see diagram).
The air intake is located at the base of the oven, even with the clearance
specified above it is important that airflow is as cool as possible and not
pre heated by other appliances such as fryers, grills or griddles.
Allow a minimum of 50mm clearance above the oven for hot air to
escape.
Allow sufficient clearance, 400mm in front of the oven for the door to
open fully
Do not affix labels/stickers to oven other than those applied by the
manufacturer
Note the minimum
recommended
clearance required for
air flow
5
Note:
The air intake is located at
the base of the oven, even
with the clearance specified
below it is important that
airflow is as cool as
possible and not pre-heated
by other appliances such as
fryers, grills and griddles as
this will deteriorate the life
and performance of the
oven.
Always ensure that ovens are
fixed together as shown using
the fixing plate provided.
THIS OVEN MUST NOT BE
STACKED MORE THAN
THREE HIGH.
Note:100mm clearance is
required between two ovens
side by side
WARNING:
Check that the
AIR FILTER is in place prior
to operation
( see Main Features )