Troubleshooting - Magic Vac Futura Instrucciones De Uso

FUTURA Ing. mew 23-12-2009
The MAGIC VAC ® does not work
• Make sure the MAGIC VAC
in properly. Check the electric socket by plug-
ging another appliance into it.
• The MAGIC VAC ® will stop automatically if over-
heated. Allow it to cool down for 15 minutes and
try again.
• Check for faults in the power cord or the plug.
Should you detect a fault, do not use the
appliance.
The MAGIC VAC ® fails to apply the first seal on
the bag cut from the roll
• Make sure the bag cut from the roll is properly
positioned as described in the paragraph:
"Making bags from MAGIC VAC
The MAGIC VAC ® does not create a complete
vacuum in the bags
• To seal the bag properly, you must make sure
that the open end remains completely inside the
Vacuum Chamber.
• Make sure that the Sealing Bar, the Sealing
Gaskets and Airtight Gaskets are free of impuri-
ties. After cleaning them, put them properly
back in place.
• The MAGIC VAC ® bag might have a hole in it. To
check it, seal the bag with air on the inside. Dip
the bag in water and apply pressure. The
appearance of bubbles means that there is a
leak.
Reseal or use another bag.
The MAGIC VAC ® does not seal the bag properly
• If the Sealing Bar overheats and melts the bag,
you may have to raise the Lid and allow the
Sealing Bar to cool down for a few minutes.
• The MAGIC VAC ® is built in conformity with cur-
rent safety standards. Overheating will cause it
to turn off automatically. Allow the appliance to
cool down for 15 minutes and try again.
The MAGIC VAC bag does not maintain a vacuum
®
after being sealed
• Leaks along the seam may be caused by creas-
es, crumbs, grease or liquids. Reopen the bag,
clean the upper inside part of the bag and
remove any foreign material from the Sealing
Bar before resealing it.
• Check that the bag has no holes in it which have
caused air to leak in. Use paper napkins to pro-
tect any sharp edges on the contents of the bag.
8:34 Pagina 6

TROUBLESHOOTING

The MAGIC VAC
containers
® has been plugged
• By means of the Connection Hose, connect the
• Leave enough room (at least 3 cm) between the
• If liquids come out during the vacuum-packing
• Check that the rim of the jar or container and
rolls"
®
• Make sure that the gasket of the container cap
MAGIC VAC
VAC
• Make sure that the arrow on the knob of the
• Make sure that the O-ring beneath the knob of
MAGIC VAC
vacuum
• Make sure that the gasket beneath the central
19
® does not create a vacuum in the
container lid (or the Cap Attachment if neces-
sary) to the Air Inlet of the appliance.
contents and the top of the jar or container.
process, remember that they must first be
chilled in a refrigerator, not left at room temper-
ature.
the universal lid are not damaged in the sealing
area. Wipe the rim and cap clean with a cloth
moistened with lukewarm water and repeat the
vacuum-packing process.
or the universal cap is set properly in place and
is not damaged.
® Executive containers or MAGIC
® Universal Caps do not maintain a vacuum
container cap is positioned on "VACUUM" before
creating a vacuum in the container and it is
positioned on "CLOSED" after a vacuum is
formed.
the container cap or the universal cap is set
properly in place.
Family containers do not maintain a
®
button (16) of the container cap is set properly in
place and is not damaged.