Warranty Claims - Atlantic FB2400 Manual Del Producto

Pull the other end of the hose from
inside the pump chamber out through
the predrilled hole onto the surface of
the Fountain Basin. Choose one of the
channels, then run the tubing to the
center of the Basin and attach the
appropriate fitting, which will depend on
the decorative fountain piece (Figure 4).
Secure with the second hose clamp.
A standpipe set just below the level of
the water overflowing a decorative pot
or vase will create an attractive bubbling
effect. Set the decorative piece over the
fitting, then attach a ½" standpipe to the
fitting. Cut the standpipe to just below
the water surface to create a bubbling
effect. Seal any gaps between the
standpipe and the hole in the base of
overflowing ceramic vases with Atlantic
SPSEAL Standpipe Sealant. To center
and stabilize the standpipe, place a few
rocks around it inside the decorative
piece to support it (Figure 5). Fill the
Basin with water, connect the pump to a
GFI-protected outlet and adjust flow as
desired.
Decoration
To complete the installation, cover the
Fountain Basin with gravel, polished
stones, glass beads or other decorative
material. To disguise the outline of the
Basin further, extend the material past
the edge of the Basin (Figure 6). To
enhance nighttime enjoyment of the
fountain, complement your Fountain
Basin with Atlantic's LED lighting.
Warranty
This product carries a lifetime warranty.
This warranty is extended solely to the
original purchaser commencing from
the date of original purchase receipt.
A misused or abused product voids
this warranty.

Warranty Claims

In case of warranty claims, the complete Basin should be returned to the place
of purchase accompanied by original receipt.
Figure 4
Figure 5
Figure 6
3