MPM MKL-01 Instrucciones De Funcionamiento página 15

FEATURES
1. Cooling by humidifying: the air from the room is taken in and passes through a cool water
spray curtain (also an ice cube tray can be used), and then is output as cooled and moistened
air.
2. Adjustable speed:
– Low
– Medium
– High
3. Humidifying function: the unit takes cool from the ice cubes and uses it to cool down and
lower the temperature of the ventilation air.
4. Swing function: after switching on the air oscillation function, the vertical louvres start mov-
ing and cause change in the direction of draught from left to right. You can also manually
change the angle of the horizontal louvres to change the draught direction from top to bot-
tom.
5. Removable air filter and cooling insert are easy to clean with a soft brush and some deter-
gent.
INSTALLATION
1. Open the box and take out the unit
2. Fill the tank with water.
– Slide out the water tank at the back of the unit.
– Pour clean water to the tank at least to the MIN mark; do not exceed the MAX level.
– For extra cooling effect, you can use cooling inserts or ice.
CAUTION FILL THE WATER TANK DIRECTLY BEFORE USING THE COOLER.
CAUTION UNPLUG THE UNIT FROM THE MAINS BEFORE FILLING THE TANK WITH WATER.
INSTRUCTIONS FOR USE
1. Speed adjustment: press 1-2-3 button to start the cooler and then change the speed of oper-
ation by pressing the buttons in the following order:
2. Swing button: press to start horizontal air output. Press again to cancel this function.
You can also manually change the angle of the horizontal louvres to change the draught
direction from top to bottom.
3. Humidification button: press to start the humidification function. If you are using cooling
packs, the air temperature in the vicinity of the unit will drop by approx. 3°C after a few min-
utes. Press this button again to cancel this function.
4. Press 0 to switch off the air cooler.
Keep the cooling packs away from children to avoid their consumption.
CAUTION IF YOU ARE PLANNING A UNIT STOPPAGE LONGER THAN 2 DAYS, UNPLUG THE POWER CABLE AND EMP-
TY THE WATER TANK.
or 1-2-3.
15