Ega Master 58770 Manual De Instrucciones página 13

Warning
- The Receiver can be operated only with the power voltage of AC100V to 240V±10%
specified in this operating instruction.
- Do not drop water or oil or any liquid on this instrument. Do not use this instrument in an
atmosphere of flammable gas and steam. Use in such an atmosphere may result in fire.
- Avoid shock or vibration to this instrument. It may cause a damage or failure.
- Before use, make a pre-operation inspection and check the settings.
- Be sure to conduct a periodic inspection of torque wrenches.
- Use a torque wrench within the measurement range specified in the operating instruction.
Should this instrument give off abnormal smell or catch fire during use, stop using it immediately
and remove the AC adapter from the outlet. Then, move the instrument to a safe place and
please contact your nearby distributor.
Caution
- Avoid using the instrument in a place where there are metal structures around it.
- Do not install the antenna for the Receiver close to any metal pole, electric wire, iron piping,
etc.
- Avoid using the instrument near welding machines, electric discharge machines or
machines producing electromagnetic noise.
- If there are different group of wireless wrenches, please configure different frequency
channel for each group, and different ID for each Receiver.
- Before wiring, check that the power of the device to be connected to the Receiver is in the
OFF position.
- Do not handle the torque wrench roughly.
- Be sure to read the operation manual of the torque wrench.
With the RF Receiver and Wireless Torque/Angle Wrench; Tightening System sends tightening
les spécifications to Wrenches and receive tightening result from Wrenches wirelessly in
real time. With this wireless Tightening System, we provide better tightening control and
management, and better quality and productivity.
OUTLINE
13