Tabla de contenido
Publicidad
Front and rear views:
Receiver
11-ON / OFF switch
12-Ring + flash, only ring and only flash switch selector
13-Flash light
14-Low battery indicator
15-Ringer volumen level switchs (High, Medium, Low)
16-Ringer tone selector
17-Wall mount
Emitter
18-Line plug
19-Telephone plug
20-Wall mount
TW130
Ring Vol
Tone
H
1
2
M
L
3
10
9
8
Instalation:
1. Insert batteries. Be sure to keep correct polarity.
2. Connect line plug to the line jack in the wall
3. Connect phone plug to your telephone
4. Both emitter and receiver allow wall mount. For better performance,
we suggest wall mount for the receiver.
Operation:
ON / OFF switch:
Slide this switch to turn on or off the ringer box power.
Ringer mode switch:
Slide the switch to select the different working modes: Ringer + flash, only
ring, only flash.
Low battery indication:
When the low battery LED indicatior lits up, you should replace batteries. It
is highly recommended to replace all batteries at the same time.
Volume switch:
Slide this switch to select the ringer volumen level: High, Medium or Low
Tone switch:
It is possible to select three different ringer tones.
TW130
Publicidad
Tabla de contenido
