Basic Operations; Turn On/Off; Function Selections; Adjust Volume Level - Soundstream H-300BAR Manual De Instrucciones

Basic Operations

Turn On/Off

When you connect the TV or an external
device to the unit, the unit will turn on
automatically. The Auto Power indicator
l i g h t i s b l u e . I t w i l l t u r n r e d w h e n
disconnected or when you turn off TV /
external device.
NOTE:
If the volume of the TV or an external
device is too low, the unit will turn off
automatically.

Function selections

While the Optical, MP3 link, Aux in
socket are connected to an external
audio device, press
Optical, MP3 link or Aux in function.

Adjust Volume Level

D u r i n g p l a y , p r e s s t h e V O L U M E + / -
b u t t o n s t o i n c r e a s e / d e c r e a s e t h e
volume level.

Super Bass Boost

Press the RS-BASS button to turn on the
bass, the indicator flashes for a longer
time (abouts 1s-2s). Press this button
again to turn off the bass, the indicator
flashes for a shorter time (about 0.5s-1s).

Mute Sound

During play, press the MUTE button to
mute sound. Press this button again or
VOL+/VOL - buttos to restore sound.
source to select
 
Program Smart Remote Control to
Control TV
You can store a total of 7 most frequent-
ly used functions of you TV in the TV
(learning zone) of smart remote control.
This feature allows you to use only one
remote control to operate all of your
TVs.
By default, the remote control codes
of a TV are stored in the smart remote
control. The available preset buttons are
ON/OFF, FUNCTION, ENTER, TV VOL+/
VOL-, TV CH+/CH-.
NOTE:
During the learning process, the normal
remote control functions are disabled.
1 Place the smart remote control (A)
within 5mm-50mm distance from TV
remote control (B).
2 Press and hold LEARN button for 2
seconds to activate the learning mode.
A red indicator on the smart remote
control (A) lights up.
3 Press one of the TV (learning zone)
buttons on the smart remote control(A),
the red indicator flashes.
4 Press the button on TV remote control
(B) that is to be stored on the smart
remote control (A). When the code is
received successfully, the red indicator
flashes 3 times, then turns red again. If
the red indicator flashes but not turn red,
the code received is unsuccessful.
5 Repeat steps 3-4 to program more
buttons on the smart remote control (A).
6 Press LEARN to save the learning and
then to exit the learning mode.
6