Quoizel LWS2323A Manual Del Usuario página 3

STEP 1:
a. Secure the Crossbar Assembly to the outlet box (not
included) with Outlet Box Screws.
b. Tighten until snug.
Note : The preassembled mounting nipple on the crossbar
should protrude outward.
STEP 2:
a. Choose desired hanging length for the light fixture.
b. Assemble the necessary rods using the 6 inch rod(s)
and/or 12 inch rod(s).
c. Pass supply wires and ground wires through the rod
assembly.
d. Attach the rod assembly to fixture.
e. Hand- tighten until snug.
Hint:
- Assemble one rod at a time.
- Pass the ground wire through the rod first.
- Then, pass the supply wire through the rod.
- Thread the rod by hand until snug.
Suggested rod length to hang fixture 30 inches above
table top:
- 8 ft. ceiling (2) 12 inch rods
- 9 ft. ceiling (2) 12 inch rods + (2) 6 inch rods
STEP 3:
a. Pass supply wires and ground wire through the fixture
loop.
b. Then thread the fixture loop to the uppermost rod.
c. Hand- tighten until snug.
STEP 4:
a. Remove the pre-assembled canopy lock ring from the
crossbar assembly.
b. Temporarily attach the ceiling canopy to the pre-
assembled nipple on the crossbar assembly.
c. Secure with canopy lock ring.
Note :
If the ceiling canopy is not snug against the ceiling,
remove it from the crossbar assembly and adjust the
length of the pre-assembled nipple by unscrewing the
pre-assembled hex nut.
Screw the nipple in or out of the crossbar until the
correct length is achieved. Then, re-attach the ceiling
canopy.
2015 QuoizelInc.
12" Rod
3
Outlet Box
Crossbar Assembly
Outlet Box Screw
6" Rod
Fixture
Fixture Loop
Rod
Canopy Chain Loop
Ceiling Canopy
Canopy Lock Ring
Nov.2015