Installation Instructions; Care And Maintenance; Troubleshooting - Project Source MQTL1037-LED10.5K830 Manual De Instrucciones

INSTALLATION INSTRUCTIONS

1. OPTIONAL: The downlight is compatible with both 5 in.
and 6 in. housing cans. The downlight is shipped to fit
in 6 in. cans and will not need to be adjusted if the
intended housing can is a 6 in. type. For 5 in. diameter
cans, adjust the mounting jaws by removing the screw
as shown, shift each bracket in and secure in place with
the same screw.
2. Make sure the power is turned off at the source to the
recessed housing(s) where the fixture(s) will be
installed. Place the lamp replacement instructions (C)
inside the housing. NOTE: This label provides
information about replacing lamps.
Screw adaptor (A) into socket in recessed housing.
3. Plug base cable connector on adaptor (A) into lamp
(B).
1
Default position
set for 6 in.
fixture housing
B
Screw Screw
position position
for 6 in. for 5 in.
housings housings
2
Ceiling
C
A
3
A
Lowes.com
6
INSTALLATION INSTRUCTIONS
4. Check the inner surface of the recessed can to see if
there are any obstructions that may interfere with the
downlight clips. If necessary, rotate the downlight to
another position to account for obstructions before
installing. Then, carefully route wires into fixture and
push recessed kit up flush to ceiling surface.

CARE AND MAINTENANCE

•
Do not modify this fixture. Any modifications may render the product unsafe.
• Before cleaning your fixture, turn off the switch or power source. Wipe the lamp with a soft,
damp cloth.

TROUBLESHOOTING

PROBLEM
Fixture does not light.
Circuit breaker trips
when light is turned
on.
B
4
POSSIBLE CAUSE CORRECTIVE ACTION
1. Power is off. 1. Check circuit breaker or wall switch.
2. Incorrect wire connection. 2. Check wire splices.
3. Defective wall switch. 3. Replace switch.
Crossed wires or power wire Verify wires are correctly connected.
is grounded out.
7
Lowes.com